What is the use of show running-config?

Use the show running-config command to display the contents of the running configuration. You can pipe the command through one of the following filters: include–shows all commands present in the running configuration which contain a match to the specified regular expression.

How do I show running-config without more?

However if u like to have freedom to choose, to execute show run without more you can use this method.

1. Type “terminal length 0” in privileged mode to set your terminal to display without any breaks.
2. Type “show run” or “show start” to show the applicable config.

What does show ip route do?

On a Cisco router, the show ip route command is used to display the IPv4 routing table of a router. A router provides additional route information, including how the route was learned, how long the route has been in the table, and which specific interface to use to get to a predefined destination.

What does show CDP neighbors do?

show cdp neighbors command provides brief information about all connected devices. Use show cdp neighbors detail or show cdp entry * commands to display additional information about connected devices. You can get device name with show cdp neighbors command.

What privilege level is show run?

show running config at privilege level 7.

How do I save my show in running config?

Save the Configuration Type “copy running-config startup-config” at the command line and press return on the keyboard. This will copy the current switch configuration to the non-volatile memory, which is memory that will retain its data even without power applied to it.

Which commands display the status of the port?

The show interfaces < port-list > command can be used to display the current link status and the port rate average over a 5 minute period.

Which information does the show interface command display?

Displays collected interface statistics and any current alarms on the specified interface.

What is show version command in Cisco?

Show version: Displays information about the router’s internal components, including the IOS version, memory, configuration register information, etc. The most common use of the show version command is to determine which version of the Cisco IOS a device is running.

How do I make my Cisco router read only?

Using Cisco Privilege Level to provide Read Only Show Run User

1. Add the new user and required privilege level to your device in config mode:username cisco priv 3 secret cisco.
2. Add the commands you wish the privilege level to have:privilege exec level 3 show run.
3. Allow file access for the privilege level:file privilege 3.

What is parser view?

Cisco IOS CLI Parser Views provide much more granular Access Control features than Privilege Levels. A CLI Parser View can be tied to a user and when the user logs in using this view, he will get only the commands which are configured for his view.

How do I get show tech output Cisco?

Solution

1. Telnet to switch.
2. Set your telnet client to capture text to a file (procedure varies based on the client).
3. Execute the following commands: # term len 0. # show tech-support details.
4. Stop capture and verify that the data shows properly in the capture file; use any text editor, such as wordpad.